Vista smoker 2.0 fulldownload

So, basically, what you're gonna do is you're going to use 22 gauge wire. Only two-wire. So we're gonna use our black and red wires out of this four-wire strand to designate positive and negative. So what you're going to do is you're going to go in and you're going to hook your positive wire into terminal eight.

And you're gonna screw that down. And then you're gonna take your negative wire and hook that into terminal nine, gotta loosen that up a little bit more. Stick it under there, screw that down, and this is gonna be your wire running out to your first smoke.

And I've got the smoke here, and I'm only working with one smoke. So this is how it's gonna look on zone one, terminals eight and nine. The wire running through the smoke. You notice I didn't put a resistor at the panel because it never goes at the panel. You do not put resistors at the panel. They are supposed to go at the end of the line. So since this is a normally open device, I've taken this resistor, right here, and I've strapped it between the positive and negative.

So it's a normally open so that the resistor is going to run in parallel between the two-wires. And then I've got my wires, I've got my positive hooked in on this first positive terminal, I've got my negative hooked in on this negative terminal. Now if you were doing more than one smoke, what you're gonna do is your wire from the panel goes to your first smoke. You put the positive right here, your negative right here, and then you're gonna run your positive for the next smoke off this middle terminal.

So you're gonna run a wire from this middle terminal to the first positive terminal on your next smoke, and your negative just runs off of this terminal. So this negative, you'll run a wire from it to the negative of the next smoke and on and on, until you get as many smokes as you need. So that's It's parallel wiring since it's a normally open. But you will only need one resistor no matter how many smokes are on this zone and that resistor will go at the last smoke and you will hook it up exactly like I have it here.

After you get done wiring your two-wire smokes into zone one, you're then going to go into programming and I've gotta keypad here so I'm gonna take you into programming. Let me get this situated.

So what you're gonna do after you hook up your two-wire smoke, let me back out of here. Say you're outside of programming. K-Lite Mega Codec Pack. K-Lite Codec Pack Update. Mozilla Firefox. Driver Booster. Windows Cannot Find Gpedit. Booo 2. Not Geeky 3. Average 4. Good 5. Major Geeks Special Offer:.

CCleaner 5. Autoruns for Windows Mupen64Plus 2. SyncBackFree Cocosenor iOS Repair Tuner 3. How to Save IncrediMail Emails 7. Top Rated ConsoleHoster 4. ConEmu Build download Open Source. Sprintbit File Manager 4. SoftPerfect File Recovery 1. System Monitor II HDShredder Free Edition 5. JavaExe 3. ExEinfo PE Win32 bit identifier 0. Driver Talent 8. DriverTurbo 3. Print Inspector 7. PC AutoTimer 3. R-Drive Image 5. Batch Files Printing 4.